Suzuki Wagon R Manual page 1387

3) Depress brake pedal gradually till fluid pressure of front
brake becomes as specified below and check corresponding
pressure of rear brake then. It should be within specification
given below.
Front brake
7,500 kPa
2
75 kg/cm
1,067 psi
4) As done above, apply 100 kg/cm
and check that rear brake pressure then is within specifica-
tion as given below.
Front brake
10,000 kPa
2
100 kg/cm
1,422 psi
5) If rear brake pressure is not within specification, adjust it by
changing bolt (2) position as follows.
• If rear brake pressure is higher than specification, move bolt
and nut (1) center side "a" and if it is lower, out side "b".
• Repeat steps 3) and 4) until rear brake pressure is within
specification.
• After adjustment, be sure to torque nut (1) to specification.
Tightening torque
LSPV nut (a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
6) Upon completion of fluid pressure test, bleed brake system
and perform brake test.
Rear brake
4,000 – 5,500 kPa
2
40 – 55 kg/cm
569 – 782 psi
2
pressure to front brake
Rear brake
4,700 – 6,200 kPa
2
47 – 62 kg/cm
668 – 882 psi
BRAKES 5-3