9-10 BODY SERVICE
INSPECTION
1) Check regulator sliding and rotating parts for greasing.
2) Check rollers for wear and damage.
3) Check wire for damage.
Window regulator
lubrication point
INSTALLATION
Reverse removal procedure to install window regulator noting fol-
lowing.
D Tighten window regulator attaching nuts to proper tightening or-
der.
Tightening Order: (a) ! (b) ! (c)
D Tighten door glass attaching screw to specified torque.
Refer to "REAR DOOR GLASS" in this section.
D When glass run (1) is installed, fit glass run convex part (2) to door
panel cut part (3).