Suzuki Wagon R Manual page 698

A
SECTION A – A
9) Install circlip (1) and confirm that circlip is installed in groove se-
curely.
Install needle bearing (2) of separated steel cage type, apply
oil to bearing.
With synchronizer outer ring (3), center cone (4) & inner ring (5)
A
put together and installed to 2nd gear (6) as shown in figure.
10) Press-fit 3rd gear (2) and spacer (1) by using special tools and
press.
CAUTION:
Press-fit 3rd gear and spacer first, and then 4th gear lat-
er separately so that counter shaft will not be com-
pressed excessively.
Special Tool
(A): 09923-78210
(D): 09913-80112
11) Press-fit 4th gear (2) by using the same procedure as the
above.
12) Install left bearing cone (1) by using special tools and hammer.
NOTE:
For protection of right bearing cone (3), always support
shaft with special tool as illustrated.
Special Tool
(A): 09923-78210
(E): 09925-98221
MANUAL TRANSMISSION 7A-27