Suzuki Wagon R Manual page 1299

3) Make sure that injector wire O-ring is free from any damage and
deterioration, and apply thin coat of spindle oil or gasoline to O-
ring.
Install injector wire and tighten new wire screw to specified
torque.
Tightening Torque
(a): 3.5 N
4) Connect battery negative cable at battery.
1. Injector wire
2. Screws
5) With engine "OFF" and ignition switch "ON", check for fuel leaks.
6) Install air chamber case mounting stay as shown left.
7) Install air chamber case.
1. Stay
ELECTRONIC CONTROL SYSTEM
ENGINE CONTROL MODULE (ECM)
CAUTION:
As ECM consists of precision parts, be careful not to ex-
pose it to excessive shock.
REMOVAL
1) Disconnect battery negative cable at battery.
2) Remove glove box (2).
3) Disconnect couplers from ECM (1) while releasing coupler lock.
4) Remove ECM from body.
INSTALLATION
1) Install ECM to body.
2) Connect couplers to ECM securely.
3) Install glove box.
4) Connect battery negative cable at battery.
ENGINE AND EMISSION CONTROL SYSTEM 6E1-17
.
m (0.35 kg-m, 2.5 lb-ft)