Suzuki Wagon R Manual page 1034

DTC 43: DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
DTC 47: PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
STEP
1 Was item "AIR BAG SYSTEM CHECK
FLOW TABLE" described in this section
performed?
2 1) With ignition switch OFF, remove center
pillar inner garnish of applicable side
then disconnect seat belt pretensioner
connector.
2) Check proper connection to applicable
seat belt pretensioner at terminals in
Q07 or Q05 connector.
3) If OK then connect Special Tools to
seat belt pretensioner connector
disconnected at 1). (See figure below.)
With ignition switch ON, is DTC 43 or 47
still current?
3 1) With ignition switch OFF, disconnect
Special Tools and SDM connector.
2) Check continuity between Q06-33 or
Q06-35 and Q06-31 terminals.
Is there continuity?
Fig. for STEP 2 and 3
Special Tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
3) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION
Fig. for STEP 3
For DTC43
YES
Go to step 2.
Go to step 3.
DTC43:
Repair short "P" or "W" wire
circuit to ground.
DTC47:
Repair short from "Lg" or
"Br" wire circuit to ground.
For DTC47
AIR BAG SYSTEM 10B-37
NO
Perform "AIR BAG
SYSTEM CHECK FLOW
TABLE" in this section.
1) Ignition switch OFF.
2) Replace seat belt
pretensioner (Refer to
SECTION 10A).
Substitute a known-good
SDM and recheck.