Suzuki Wagon R Manual page 794

1. Snap ring
ASSEMBLY
1) Install new D-ring (5) to front clutch No.1 drum.
Apply grease to D-ring and fit it to drum.
"A": Grease 99000-25030
2) Install piston (4) into front clutch No.1 drum (6).
Use care that the piston lip does not get twisted or caught.
Apply grease to the lip of the piston.
"A": Grease 99000-25030
3) Install front clutch return spring (3) seat and front clutch balancer
(2).
4) Install shaft snap ring (1).
Compress return springs and install shaft snap ring in groove by
using a flat end rod or the like (3).
Place special tool (clutch spring compressor) on spring seat and
compress springs with a press (2).
CAUTION:
Do not compress return spring more than necessary.
Special Tool
(A): 09926-96010
5) Install discs, plates and flange (1) in following order.
(1) Plate ! (2) Disc ! (3) Plate ! (4) Disc ! (5) Plate ! (6) Disc
! (7) Plate ! (8) Disc ! (9) Flange
NOTE:
Before assembly, new discs should be soaked in automatic
transmission fluid for at least 2 hours.
AUTOMATIC TRANSMISSION (4 A / T) 7B-83