Suzuki Wagon R Manual page 1420

7A-4 MANUAL TRANSMISSION
On-Vehicle Service
Differential Side Oil Seal
REPLACEMENT
1) Lift up vehicle and drain transmission and transfer oil.
2) Remove wheel, and then remove tie-rod end nut.
3) Disconnect tie-rod end from knuckle by using puller (1).
4) Remove two stabilizer mount brackets from vehicle body.
5) Remove ball stud bolt and then separate suspension arm
from knuckle.
6) Separate transfer from transmission assembly.
For detail, refer to Section 7D.
7) By using large size screwdrivers (2), pull out drive shaft joint
(1) so as to release snap ring fitting of joint spline at differen-
tial side.
Pushing knuckle portion outward, detach drive shaft at differ-
ential side.
8) Remove oil seal (1) and install a new one until it becomes
flush with case surface by using special tool and hammer.
NOTE:
When installing oil seal, face its spring side inward.
Special tool
(A) : 09913-75510 (LH)
(A) : 09951-46010 (RH)
9) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal contacts and make sure of its smooth-
ness.
"A" : Grease 99000-25010
10) Install transfer to transmission referring to Section 7D.