Suzuki Wagon R Manual page 681

7A-10 MANUAL TRANSMISSION
D Adjustment of select cable.
With shift control lever in NEUTRAL position, adjust select cable
adjusting nut (3) so that the tip of select arm (cable joint point) (1)
and the center rib of gear shift control lever assembly (2) are
aligned as shown.
NOTE:
After select cable adjustment, tighten lock nut (4) to speci-
fied torque.
Tightening Torque
.
(a): 5.5 N m (0.55 kg-m, 4.0 lb-ft)
VEHICLE SPEED SENSOR (VSS)
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect VSS coupler (1).
3) Remove VSS.
INSTALLATION
1) Check O-ring (1) and VSS surface for their flawlessness, apply
oil to O-ring and then install VSS to transmission.
2) Connect VSS coupler (1).
3) Connect negative cable at battery.