Component Inspection - Suzuki Wagon R Manual

7D-10 TRANSFER
4) Drive out bevel pinion shaft from transfer output retainer by
tapping with plastic hammer.
5) Drive out pinion spacer from bevel pinion shaft.
6) Drive out pinion shaft bearing (2) from bevel pinion shaft (1)
by using hydraulic press.
3. Bearing puller
7) Remove pinion shaft oil seal (1) by using special tool.
Special tool
(A) : 09913-50121
8) Drive out pinion shaft bearing outer races (2) (front and rear)
by using brass bar (1).

Component Inspection

• Check each bearing for smooth rotation, wear or discolora-
tion.
If found abnormal, replace.
• Check oil seal for leakage and its lip for excessive hardness.
If either is found, replace.
• Check transfer case for cracks.
• Check bevel pinion and bevel gear for wear or cracks.
• Check pinion gear and pinion shaft for wear or damage.