Fuel Injector - Suzuki Wagon R Manual

1. Injector coupler
2. TP sensor
3. Water hose
4. Vacuum hose
5. ISC actuator
6. Fuel return hose
7. Fuel feed hose
1. Injector coupler
Good No good
ENGINE AND EMISSION CONTROL SYSTEM 6E1-15
2) Install throttle body to EFE heater and tighten bolts to specified
torque.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
3) Install accelerator cable to throttle valve lever and cable brack-
et.
4) Connect fuel, cooling water and vacuum hoses to throttle body,
and clamp securely.
5) Connect TP sensor and injector couplers securely.
6) Refill cooling system referring to Section 6B.
7) Connect negative cable at battery.
8) With engine "OFF" and ignition switch "ON", check for fuel
leaks around fuel line connection.
9) Install air chamber case.
10) Upon completion of installation, start engine and check for fuel
leaks and engine coolant leaks.
Adjust accelerator cable to specification according to proce-
dure described in ACCELERATOR CABLE ADJUSTMENT.

FUEL INJECTOR

ON-VEHICLE INSPECTION
1) With battery negative cable disconnected, disconnect injector
coupler.
2) Connect ohmmeter to each injector terminal and measure resis-
tance.
Resistance of injector: 0.5 – 1.5 Ω at 20_C (68_F)
If resistance is out of specification, replace fuel injector.
3) Connect injector coupler.
4) Remove air chamber case.
5) Check that fuel is injected out in conical shape from fuel injector
when cranking or running engine.
If no fuel is injected, check wiring harness for continuity and cou-
plers for proper connection referring to "DIAGNOSTIC FLOW
TABLE B-1".
If fuel is not injected out in conical shape, replace injector.
6) Check injector for fuel leakage after injection is stopped (i.e., af-
ter cranking or engine stop).
Replace if leakage exists.
Fuel leakage: Less than 1 drop/min.
7) Install air chamber case.