Suzuki Wagon R Manual page 793

7B-82 AUTOMATIC TRANSMISSION (4 A / T)
4) Remove front clutch balancer (1) and front clutch return spring
seat (2).
5) Remove front clutch piston (3).
Blow compressed air through input shaft oil hole to remove pis-
ton. If piston does not pop out, take it out with long nose pliers.
6) Remove D-ring (4) from front clutch No.1 drum (5).
5
4
INSPECTION
Clutch Discs, Plates and Flange
Check that sliding surfaces of discs, plates and flanges are not worn
or burnt. If necessary, replace.
NOTE:
D If disc lining is exfoliated or discolored, replace all discs.
DBefore assembling new discs, soak them in A/T fluid for at
least two hours.
Front Clutch Return Spring Seat
Measure height of front clutch return spring.
Specified value: 13.85 mm (0.545 in.)
NOTE:
D Do not apply excessive force when measuring spring height.
D Perform measurement at several points.
Front Clutch Piston Lip and Front Clutch Balancer Lip
Check each lip for wear, deformation, cut, and/or hardening. If nec-
essary, replace.