Suzuki Wagon R Manual page 1249

6A-58 ENGINE MECHANICAL
4) Install piston and connecting rod assembly into cylinder bore.
Use special tool (Piston ring compressor) to compress rings.
Guide connecting rod into place on crankshaft.
Using a hammer handle, tap piston head to install piston into
bore. Hold ring compressor firmly against cylinder block until all
piston rings have entered cylinder bore.
Special Tool
(A): 09916-77310
5) Install bearing cap (1):
Point arrow mark (2) on cap to crankshaft pulley side (3).
Tighten cap nuts (4) to specification.
Tightening Torque
.
(a): 35 N m (3.5 kg-m, 25.5 lb-ft)
6) Reverse removal procedure for installation, nothing the follow-
ing points.
D Adjust water pump drive belt tension, referring to "ENGINE
COOLING" section.
D Adjust A/C compressor belt tension, if equipped.
Refer to Section 1B.
D Adjust accelerator cable play. Refer to Section 6E1.
D Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
D Refill engine with engine oil, referring to item "ENGINE OIL
CHANGE" in Section 0B.
D Refill cooling system referring to Section 6B.
D Connect negative cable at battery.
D Verify that ignition timing is within specification referring to
"IGNITION SYSTEM" section.
D Verify that there is no fuel leakage, coolant leakage, oil leak-
age and exhaust gas leakage at each connection.