Suzuki Wagon R Manual page 1020

DTC 16: PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE LOW
STEP
1 Was item "AIR BAG SYSTEM CHECK
FLOW TABLE" described in this section
performed?
2 1) With ignition switch OFF, disconnect
passenger air bag (inflator) module
connector behind the glove box.
2) Check proper connection to passenger
air bag (inflator) module at terminals in
Q02 connector.
3) If OK then connect Special Tool (B) to
Q02 connector in stead of passenger
air bag (inflator) module. (See figure
below.)
With ignition switch ON, is DTC 16 current?
3 1) With ignition switch OFF, disconnect
SDM connector.
2) Check proper connection to SDM at
terminals Q06-23 and Q06-24.
3) Release shorting bar in SDM connector
by inserting special tool (A), referring to
the figure below.
4) Measure resistance between terminals
Q06-23 and Q06-24 with connected
Special Tool (B). (See figure below.)
Is resistance 1.2 Ω or more?
Fig. for STEP 2 and 3
Q02 connector
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
3) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION YES
Go to step 2.
Go to step 3.
Substitute a known-good
SDM and recheck.
Fig. for STEP 3
AIR BAG SYSTEM 10B-23
NO
Perform "AIR BAG
SYSTEM CHECK FLOW
TABLE" in this section.
1) Ignition switch OFF.
2) Replace passenger
air bag (inflator)
module.
Repair short from "Y" wire
circuit to "Y/R" wire circuit
or from "Y" or "Y/R" wire
circuit to other wire circuit.