Suzuki Wagon R Manual page 1440

7C-2 CLUTCH
Unit Repair Overhaul
Clutch Release System
REMOVAL
1) Remove ß-pin from release shaft.
2) Remove release lever by loosening its nut.
3) Take out release bearing by turning release shaft (1).
4) Unhook return spring by using pliers.
5) Drive out No.2 bush by using special tool and hammer.
Release shaft seal will also be pushed out.
Special tool
(A) : 09922-46010
6) Remove release shaft and return spring.
7) Install tap (M16 X 1.5) (1) to clutch release shaft No.1 bush.
8) Pull out No.1 bush by using tap (1) and special tools.
Special tool
(B) : 09923-46020
(C) : 09930-30104
INSPECTION
Clutch release bearing
Check clutch release bearing for smooth rotation.
If abnormality is found, replace it.
CAUTION:
Do not wash release bearing. Washing may cause grease
leakage and consequential bearing damage.