Suzuki Wagon R Manual page 1004

BASE OF COLUMN
PASSENGER INFLATOR
STEERING WHEEL
An SDM short bar release tool is included in the connector test
adapter kit.
Inserting it into the SDM connector will release the shorting bar.
Special Tool (Air Bag Driver/Passenger Load Tool)
(B): 09932-75010
This tool is used only when called for in this section. It is used as
a diagnostic aid and safety device to prevent inadvertent air bag (in-
flator) module deployment and seat belt pretensioner activation.
The load tool has three connectors attached to its case which are
electrically functional and serve as resistive load substitutions.
One of connectors ("STEERING WHEEL") is used to substitute the
load of the followings.
D driver air bag (inflator) module when it is connected at the top of
the column to the contact coil assembly.
D passenger air bag (inflator) module when it is connected to the air
bag harness connector for passenger air bag (inflator) module.
D driver and passenger seat belt pretensioner when it is connected
to air bag harness connector for driver and passenger seat belt
pretensioner.
The other connectors ("BASE OF COLUMN" and "PASSENGER
INFLATOR") are not used for this vehicle.
By substituting the resistance of the load tool when called for, a de-
termination can be made as to whether an inflator circuit compo-
nent is causing system malfunction and which component is caus-
ing the malfunction.
The load tool should be used only when specifically called for in the
diagnostic procedures.
AIR BAG SYSTEM 10B-7