Suzuki Wagon R Manual page 1057

10B-60 AIR BAG SYSTEM
18) Dispose of the deployed air bag (inflator) module and the acti-
vated seat belt pretensioner through normal refuse channels
after it has cooled for at least 10 minutes and tightly seal the air
bag (inflator) module and the seat belt pretensioner in a strong
vinyl bag. (Refer to "Deployed Air Bag (Inflator) Module and Ac-
tivated Seat Belt Pretensioner Disposal" in detail.)
19) Wash your hands with mild soap and water afterward.
NOTE:
The remaining steps are to be followed in the unlikely event
that the air bag (inflator) module did not deploy or the seat belt
pretensioner did not activate after following these proce-
dures.
20) Ensure that the deployment harness has been disconnected
from the power source and that its two banana plugs have been
shorted together by fully seating one banana plug into the oth-
er.
21) Disconnect the deployment harness and cables from the air
bag (inflator) module and the seat belt pretensioner.
22) [For air bag (inflator) module]
Temporarily store the air bag (inflator) module with its vinyl trim
cover facing up, away from the surface upon which it rests. Re-
fer to "Service Precautions" in this section for details.
[For seat belt pretensioner]
When temporarily storing the seat belt pretensioner. Refer to
"Service Precautions" in this section for details.
23) Contact your local distributor for further assistance.