Suzuki Wagon R Manual page 520

10) Disconnect following electric wires:
D Back-up light switch (M/T)
D Shift switch (A/T)
D Forward clutch revolution sensor (4 A/T)
D A/T vehicle speed sensor (A/T)
D Battery negative cable from transmission
D Vehicle speed sensor
D e.t.c.
and release above wire harness from clamps.
11) Disconnect fuel feed hose (1) from fuel delivery pipe.
12) Disconnect heater inlet and outlet hoses.
13) Remove right and left engine under covers.
14) Disconnect oxygen sensor No.2 coupler (1) and remove ex-
haust No.1 pipe (2).
15) Drain engine and transmission oil.
16) Remove stabilizer bar (1) referring to Section 3D.
1
17) Remove drive shaft joints from differential gear of transmis-
sion.
Refer to Section 4 (DRIVE SHAFT) for procedure to disconnect
drive shaft joint.
For engine and transmission removal, it is not necessary to re-
move drive shafts from steering knuckle.
ENGINE MECHANICAL 6A1-65