Suzuki Wagon R Manual page 1227

6A-36 ENGINE MECHANICAL
D As camshaft housing No.1 (1) retains camshaft in proper
position as to thrust direction, make sure to first fit No.1 hous-
ing to No.1 journal of camshaft securely.
2. No.2 housing
3. No.3 housing
D After applying engine oil to housing bolts, tighten them tem-
porarily first. Then tighten them by following sequence as
shown in figure.
Tighten a little at a time and evenly among bolts and repeat
tightening sequence three to four times before they are tight-
ened to specified torque.
Special Tool
(A): 09919-16010
Tightening Torque
(a): 11 N
5) Install camshaft oil seal.
After applying engine oil to oil seal lip, press-fit camshaft oil
seal till oil seal surface becomes flush with housing surface.
6) Install camshaft timing belt pulley (1) to camshaft (2) after
installing dwell pin to camshaft.
With locking camshaft by using special tool, tighten pulley bolt
(3) to specified torque.
Tightening Torque
(b): 60 N
Special tool
(A): 09917-68220
7) Install cylinder head cover to cylinder head as previously out-
lined.
8) Install timing belt, timing belt outside cover, crankshaft pulley,
water pump pulley and water pump belt as previously outlined.
9) Install distributor case and distributor.
Refer to Section 6F for installation.
10) Connect negative cable at battery.
11) Adjust ignition timing.
Refer to Section 6F for adjustment.
.
m (1.1 kg-m, 8.0 lb-ft)
.
m (6.0 kg-m, 43.5 lb-ft)