Suzuki Wagon R Manual page 1423

REMOVAL
1) Remove console box.
2) Disconnect gear shift and select control cables (1) from gear
shift control lever assembly (2).
a) Disconnect cable end from pivot while pushing cable end
bush (4).
b) Detach cable from bracket (5) while pulling pin (6).
3) Remove gear shift control lever assembly mounting nuts (3)
and gear shift lever assembly from body.
4) Disconnect shift and select cables from transmission in the
same manner as step 2).
5) Remove cable grommet and cable clamp, and then remove
shift and select cables from body.
INSTALLATION
Reverse removal procedure for installation and note as follows.
• Apply grease to pin ends (1) before installing shift and select
cable ends to pin ends.
"A" : Grease 99000-25010
• Tighten gear shift control lever assembly mounting nuts to
specified torque.
Tightening torque
Gear shift control lever assembly nuts
(a) : 13 N·m (1.3 kg-m, 9.5 lb-ft)
MANUAL TRANSMISSION 7A-7