Suzuki Wagon R Manual page 1121

SCAN TOOL DATA
DESIRED IDLE
(DESIRED IDLE SPEED)
TP SENSOR VOLT
( (THROTTLE POSITION
SENSOR OUTPUT
VOLTAGE)
INJ PULSE WIDTH
( (FUEL INJECTION
PULSE WIDTH)
IAC FLOW DUTY (IDLE
AIR CONTROL FLOW
DUTY)
TOTAL FUEL TRIM
BATTERY VOLTAGE
CANIST PRG DUTY
(EVAP CANISTER
PURGE FLOW DUTY)
CLOSED THROT POS
(CLOSED THROTTLE (CLOSED THROTTLE
POSITION)
FUEL CUT FUEL CUT
RAD FAN
( (RADIATOR FAN
CONTROL RELAY)
ELECTRIC LOAD ELECTRIC LOAD
A / C SWITCH A/ C SWITCH
FUEL TANK LEVEL
BAROMETRIC PRESS
FUEL PUMP
CONDITION
At idling with no load after warming up, M / T g
at neutral, A / T at "P" range
Throttle valve fully closed
Ignition switch
ON/ engine ON/ engine
stopped
Throttle valve fully open
At specified idle speed with no load after
warming up
At 2500 r / min with no load after warming up
At idling with no load after warming up
At specified idle speed after warming up
Ignition switch ON / engine stop
At specified idle speed after warming up
Throttle valve at idle position
Throttle valve opens larger than idle position
When engine is at fuel cut condition
Other than fuel cut condition
Engine coolant temp.:
Lower than 91.5_C
Ignition switch
ON ON
Engine coolant temp.:
Ignition switch ON / Headlight, small light,
heater fan and rear window defogger all
turned OFF
Ignition switch ON / Headlight, small light,
heater fan or rear window defogger turned
ON
Engine running after warming up, A / C not
operating
Engine running after warming up, A / C
operating
––––––––––––
––––––––––––
Within 3 seconds after ignition switch ON or
engine running
Engine stop at ignition switch ON.
GENERAL INFORMATION AND ENGINE DIAGNOSIS 6-1-29
g ,
(197_F)
96_C (205_F) or higher
NORMAL CONDITION /
REFERENCE VALUES
800 r / min 800 r / min
More than 0.2 V
Less than 4.8 V
0.8 – 2.3 msec.
0.8 – 2.3 msec.
20 – 40%
– 35 – +35%
10 – 14 V
0 – 100%
ON
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
ON
0 – 100%
Display the barometric pressure
ON
OFF