Suzuki Wagon R Manual page 1503

0A-4 GENERAL INFORMATION
WARNING:
SDM
• For handling and storage of a SDM, select a place where the ambient temperature below 65°C
(150°F), without high humidity and away from electric noise.
• During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM).
Never strike or jar the SDM.
• Never power up the air bag system when the SDM is not rigidly attached to the vehicle. All SDM and
mounting bracket fasteners must be carefully torqued and the arrow must be pointing toward the
front of the vehicle to ensure proper operation of the air bag system.
The SDM could be activated when powered while not rigidly attached to the vehicle which could
cause deployment and result in personal injury.
WARNING:
Driver and Passenger Seat Belt Pretensioners :
• For handling and storage of a live seat belt pretensioner, select a place where the ambient tempera-
ture below 65°C (150°F), without high humidity and away from electric noise.
• Never carry seat belt pretensioner by webbing.
• When placing a live seat belt pretensioner on the workbench or other surface, it is also prohibited
to put a seat belt pretensioner on top of another. Otherwise, personal injury may result.
• Never dispose of live (inactivated) seat belt pretensioners (drive and passenger). If disposal is nec-
essary, be sure to activate them according to activation procedures described in Section 10B before
disposal.
• The seat belt pretensioner immediately after activation is very hot. Wait for at least half an hour to
cool it off before proceeding the work.
• With many service procedures, gloves and safety glasses should be worn to prevent any possible
irritation of the skin or eyes.