Inspection And Adjustment; Brake Disc Thickness; Brake Disc Runout - Ezgo 1600xd Repair Manual

4. INSPECTION AND ADJUSTMENT

4.1 BRAKE DISC THICKNESS

1. Measure the thickness of the front/rear brake discs
with a micrometer.
Standard disc thickness: 4.0 mm (0.157 in.)
Allowable limit: 3.5 mm (0.138 in.)
IMPORTANT
• Check if the surface of the disc is worn unevenly,
scratched or split. If an abnormal condition is
found, replace it with a new one.
2. Measure the thickness of the parking brake disc
with the same procedure.
Standard disc thickness: 4.0 mm (0.157 in.)
Allowable limit: 3.5 mm (0.138 in.)
8
-6
BRAKE - INSPECTION AND ADJUSTMENT

4.2 BRAKE DISC RUNOUT

UUVW703A
1.
2.
Set a dial gauge on top of the lower arm of the rear
axle. Measure the runout while turning the hub left
and right with the sensor in contact with the side
of the brake disc lightly.
Standard runout: 0.254 mm (0.01 in.) or lower
Measure the runout of the parking brake disc with
the same procedure.
Standard runout: 0.35 mm (0.0138 in.) or lower
UUVW704A
SUUV-W00 Apr. 2011