●
ASSEMBLY
1.
Be careful not to drop the engine stop solenoid
guide (1) when installing the stop solenoid.
2.
When installing the governor spring, make sure that
the governor spring 2 (1) is installed on the inside
of the governor spring 1 (2).
CAUTION
•
Be careful of the direction of the governor spring
1. The longer side should face the governor fork.
•
If the governor spring is dropped during the
installation, the crank case should be disassembled
again. Therefore, use a hook not to drop the governor
spring.
3
-62
ENGINE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW2A2A
UUVW2A3A
UUVW2A4A
6.2.4 FUEL CAMSHAFT (GEAR CASE)
1.
Unscrew the crankshaft mounting nut (1), and re-
move the fan drive pulley (2) using a puller.(29mm)
Mounting nut
tightening torque ............137.3 ~ 156.9 Nm
UUVW270A
UUVW271A
14.0 ~ 16.0 kgf-m
101.3 ~ 115.7 lb-ft
SUUV-W00 Apr. 2011