Shift Cable Length; Front Wheel Drive Cable Length - Ezgo 1600xd Repair Manual

4.4 SHIFT CABLE LENGTH

Put the shift lever to the "N" position. Then, adjust
1.
the length of the section A of the gear selector ca-
ble using the nut on the adjusting screw at its lever
side mounting section.
Set length for section A: 40 mm (1.575 in.)
2. Put the shift lever to the "N" position. Then, adjust
the length of the section B using the nut on the ad-
justing screw at the mounting section on the shift
arm side.
To adjust the set length for the section B, set the
shift lever in the neutral state on the transmis-
sion case side, pull the cable gently to fi t it into the
mounting bracket, and then adjust the cable length
so that the lever can be moved to each gear posi-
tion freely. Then, tighten the mounting nut.
5
-12
TRANSMISSION - INSPECTION AND ADJUSTMENT
UUVW503A
UUVW504A

4.5 FRONT WHEEL DRIVE CABLE LENGTH

Set the differential lock lever to the "UNLOCK" po-
1.
sition. Then, adjust the differential lock cable length
to the bracket with the nut on the adjusting screw
from its mounting sections on both sides.
Set length for section E: 40 mm (1.575 in.)
2. To adjust the set length for the section F, set the dif-
ferential lever in the "UNLOCK" position on the rear
axle case side, pull the cable gently to fi t it into the
mounting bracket, and then adjust the cable length
so that the lever can be moved to the "LOCK" posi-
tion freely. Then, tighten the mounting nut.
UUVW507A
UUVW508A
SUUV-W00 Apr. 2011