Driven Pulley Assembly Components Disassembly And Assembly - Ezgo 1600xd Repair Manual

CAUTION
1. When reassembling the drive pulley assembly
(driving part CVT assembly), tighten the impel-
ler cover bolt to the diagonal direction gradu-
ally by turns.
2. Apply the adhesive equivalent LOCTITE #271
to the following screw thread.
• Impeller cover mounting bolt
• The shaft of fi xing pulley assembly and the
attaching area of spider assembly
• Centrifugal lever lock nut
3. After disassembling the lock nut of centrifugal
lever, you should replace it with new one to as-
semble.
SUUV-W00 Apr. 2011
5.4 DRIVEN PULLEY ASSEMBLY COMPONENTS
DISASSEMBLY AND ASSEMBLY
1. As the cam block (1) of the driven pulley is pressed
into the mounting fl ange, the driven pulley cannot
be disassembled. If its malfunction or damage is
found, the whole driven pulley assembly should be
replaced.
REMARK
• If the clutch button (2) is worn, replace it. Refer to
"How to change the clutch button" in section 4.2.
UUVW352A
4
-17