5.12.7 VALVE CAMSHAFT DEFLECTION CHECK
1.
Place the camshaft on V blocks with its journals
supported and set a dial indicator with its tip on the
intermediate journal.
2.
Measure the eccentricity (half of the measured value)
while turning the camshaft on the V blocks.
3.
If the eccentricity exceeds the allowable limit, re-
place the camshaft.
Allowable
Eccentricity
limit
SUUV-W00 Apr. 2011
ENGINE - INSPECTION AND ADJUSTMENT
5.12.8 VALVE CAM HEIGHT MEASUREMENT
UUVW220A
1.
2.
0.08 mm
0.0031 in.
Measure the height of the camshaft lobe at largest
O.D. with an outside micrometer.
If the measured value is below the allowable limit,
replace the camshaft.
Specifi cation
Cam height
Allowable
limit
UUVW221A
26.83 mm
(1.0563 in.)
26.75 mm
(1.0531 in.)
3
-49