Ezgo 1600xd Repair Manual page 200

3. Unscrew the speed control lever bracket adjust-
ing nut (1) on the engine side and disconnect the
cable.
4. Pull out the cable mounting snap pin (1) on the ac-
celerator lever side and unscrew the cable adjust-
ing nut (2) from the bracket to disconnect the cable.
6
-12
CHASSIS - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW563A
UUVW565A
5. Unscrew the accelerator lever mounting double
nut and remove the nut (1), plain washer (2), plate
spring (3), bracket (4), brake lining (5) and accel-
erator lever (6).
6. Assemble in reverse order of disassembly.
IMPORTANT
• To adjust the cable length, lower the accelerator
lever to the lowest position of the guide and fi t its
cable end on the engine side to the speed control
lever groove. Then, install the cable to the speed
control lever bracket, pulling it gently with the
speed control lever not pulled up, and tighten the
adjusting nut to secure it.
7. When installing the accelerator lever to the bracket,
make sure to install the plate springs facing each
other (convex side outward) and tighten the double
nut to secure them.
UUVW566A
UUVW564A
SUUV-W00 Apr. 2011