Flasher Unit (Optional); Engine Stop Relay (5P) - Ezgo 1600xd Repair Manual

5.16 FLASHER UNIT (OPTIONAL)

The fl asher unit is attached to the relay bracket un-
der the hood.
TERMINAL IDENTIFICATION AND CIRCUIT
Flasher unit
Fuse
Turn signal
lamp
switch
DC12V
This shows terminals and circuit of the fl asher unit.
FLASHER UNIT TEST
A 12-volt battery and auxiliary light are needed to test
the fl asher unit. Install the battery's positive cable to the
terminal B of the fl asher unit. Install the light's positive (+)
lead to the terminal L of the fl asher unit. Install the light'
s negative (-) lead to the battery's negative terminal. The
light will fl ash and the unit will make a clicking sound if
the unit is functioning properly.
Replace the flasher unit if the test result does not
match above.
SUUV-W00 Apr. 2011
ELECTRIC SYSTEM - ELECTRICAL COMPONENTS
UUVWA30A
Hazard
warning
flasher
switch
Lamp
T46WB56A

5.17 ENGINE STOP RELAY (5P)

The engine stop relay is attached to the relay
bracket under the hood.
This relay is used as power supply to the pull coil of the
engine stop solenoid.
RELAY TEST
T46WB60A
To perform the relay test, disconnect and remove the
relay from the wiring.
Check the resistance and continuity within the resis-
tance range (Ω) of a tester.
Numbers on the auxiliary relay terminals indicate cor-
responding coil and contact.
• Capacity: 40A
UUVWA31A
Terminal diagram
T46WB61A
12
-35