Ezgo 1600xd Repair Manual page 226

IMPORTANT
• The splined end of the CV joint is equipped with
the inner-extensible snap ring. When removing
the CV joint, apply impact to the CV joint gently
with a lever to remove it. When installing it, tap it
in gently with a rubber hammer.
• When installing the rear axle drive shaft to the
rear axle case, be careful not to miss the O-ring
and make sure to apply grease on it.
7. Unscrew the parking brake caliper mounting bolts
(1) to remove the parking brake caliper assembly (2).
(Refer to chapter "Brake" for details.)
7
-16
REAR AXLE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW624A
UUVW685A
8. Disconnect the bleeder hose (1) and differential
lock cable (2) and unscrew the mounting bolts (3)
(M10, 4 EA) with the 14 mm socket wrench to re-
move the rear axle case assembly with the rear
universal joint.
9. Pull out the spring pin (1) that connects the rear
axle case assembly and rear universal joint to sep-
arate the rear axle case assembly.
UUVW622A
UUVW623A
SUUV-W00 Apr. 2011