Njection Pump Gear Assembly; (Fuel Camshaft Gear); Engine Oil Relief Valve - Ezgo 1600xd Repair Manual

6.3.8 INJECTION PUMP GEAR ASSEMBLY

(FUEL CAMSHAFT GEAR)

1. Pull out the snap ring (1) and remove the injection
pump gear assembly. This assembly is forcibly
pressed into the shaft, so a special device may be
used for its disassembly.
2. Remove the clip (2) to separate the gear (3) and
the bearing (4).
3. Take out the ball (5).
4. Take out the key (6) and remove the #6305 bearing
(7) and #6305Z bearing (8).
5. Install in the reverse order of removal.
6. When installing the injection pump gear, heat it to
approx. 80°C (176°F) and fi t it to the camshaft.
3
-76
ENGINE - DISASSEMBLY, SERVICE AND ASSEMBLY
S76W2Q3A

6.3.9 ENGINE OIL RELIEF VALVE

(1) Relief valve ball
(2) Relief valve seat
(3) Relief valve spring
1. Remove the relief valve.
2. Check the relief valve for dirt, and the seat (2), spring (3)
and ball (1) for damage.
3. If damaged, replace.
REMARK
Install the relief valve cover with the mark ▲up.
•
Relief valve cover bolt
tightening torque ............
2
1
3
196W2F5B
32.4 ~ 36.3 Nm
3.3 ~ 3.7 kgf-m
23.9 ~ 36.8 lb-ft
SUUV-W00 Apr. 2011