Inspection And Adjustment; Adjusting Distance Between Shafts For Pulleys - Ezgo 1600xd Repair Manual

4. INSPECTION AND ADJUSTMENT

4.1 ADJUSTING DISTANCE BETWEEN SHAFTS FOR PULLEYS

When the distance between the shafts and offset val-
ues are uncertain during the inspection of the CVT or
installation of the engine or gear box, perform the fol-
lowing procedures to measure the distance between
shafts and offset value for the engine fl ywheel and gear
box input shaft.
1. Fit the shaft alignment setting jig to the gear box
input shaft and the engine fl ywheel.
2. Measure the gap between jig and the step on the
gear box input shaft as shown in the picture. The
gap should be in ± 1mm (0.03937 in.).
3. If everything is OK, tighten the mounting bolts for
engine of gear box as needed.
4. For detailed information about adjustment, refer to
"5.2 CVT Assembly."
SUUV-W00 Apr. 2011
CVT - INSPECTION AND ADJUSTMENT
•
Part number : UCVT-P00
UUVW477A
UUVW304A
REMARK
Shafts & offset measuring jig (without adapter
attached)
UUVW243A
mm.
UUVW303A
4
-9