Ezgo 1600xd Repair Manual page 234

3. When installing the band, align the band with the
boot mounting groove, nip the protrusion, pull the
outer band and hook the band to the hook.
Housing
4. Remove the housing stop ring (1) from the CV joint.
Then, separate the joint as a unit.
7
-24
REAR AXLE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW654A
UUVW655A
Cup
UUVW656A
5. Pull out the snap ring (1). Then, remove the ball
joint guide (2), case (3), ball (4) and rubber bellows
(5) in order.
6. For reassembly, fi t the rubber bellows to the shaft,
insert the ball joint case, fi t the ball joint guide and
fi t the snap ring. Then, fi t the ball into the hole, push
it in along the housing groove and fi t the stop ring.
IMPORTANT
• During assembly, fill the rear axle drive shaft
housing with a sufficient amount of grease.
Make sure to apply grease to the ball and case
assembly.
UUVW657A
UUVW658A
SUUV-W00 Apr. 2011