When The System Is Not Preheated Automatically - Ezgo 1600xd Repair Manual

ELECTRIC SYSTEM - DIAGNOSIS AND TROUBLESHOOTING

7.2.5 WHEN THE SYSTEM IS NOT PREHEATED AUTOMATICALLY

Check point
1. Check the battery - Measure the voltage between battery (+)
voltage and (-) terminals using a tester
- Result: 11.8 ~ 12.9 V
However, the voltage may be over this
range if it is measured immediately after
turning the engine off.
- Continue to the next step.
2. Battery terminal of 1. Proper connection of battery cable
start motor
- The voltage between start motor's M
2. When voltage is not supplied
- Check proper connection of battery
- Check the corrosion
- Continue to the next step.
3. Slow blow fuse - Fuse engagement
- Short circuit of main fuse
Rated capacity: 60A
4. Key switch Check proper connection
"ON" position: A-B-D
"PREHEAT" position: A-C-D
5. Preheat relay 1. With key ON, connect 12 V to No. 85 and
86 terminals : No. 87 and 30 terminals
connected (closed circuit)
2. Not connecting 12 V to No. 85 and 86 termi-
nals : No. 87 and 30 terminals open circuit
12
-60
Check item (method)
terminal and chassis should be approx-
imately same as the battery voltage.
cable
Remarks
T46WBB9A
T46WBC0A
T46WBC1A
A - Battery
B - Accessory
C - Engine heat
D - Key s/w on
E - Start
T46WBC2A
T46WBC3A
SUUV-W00 Apr. 2011