Ezgo 1600xd Repair Manual page 118

7. Unscrew the two air cleaner mounting bolts (M8,
1) and two intake duct mounting nuts (M8, 2) using
the 12 mm spanner to remove the air cleaner as-
sembly.
8. Unscrew the one alternator guide mounting bolt
(M8), two gear case bracket mounting bolts (M6,
1), two cooling fan mounting bolts (M8, 2) and four
retainer bolts (M6, 3) using the 12 mm spanner (T
type) and 10 mm spanner to remove the cooling
fan, retainer, alternator and fan belt.
3
-80
ENGINE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW2C3A
UUVW2C4A
9. Undo the coolant hose band to disconnect the
coolant hose (1). Then, disconnect the engine stop
solenoid connector (2) and accelerator wire (3) and
unscrew the four speed control plate cover mount-
ing bolts and nuts (M6, 4) using the 10 mm span-
ner to open the cover and disconnect the governor
spring. (See 6.2.3 "Speed control plate and gover-
nor spring.")
10. Unscrew the crankshaft pulley mounting nut using
the 29 mm socket wrench.
Make sure that the pulley does not rotate by sup-
porting its inner angular part with a jig when un-
screwing the pulley mounting nut.
UUVW2C5A
UUVW2C6A
SUUV-W00 Apr. 2011