Ezgo 1600xd Repair Manual page 106

●
ASSEMBLY
1. Install in the reverse order of removal.
2. When installing the main bearing case cover, make
sure that the mark "UP" on it faces the upper side.
Also, tighten its outer bolts fi rst and then its inner
bolts.
Mounting bolt
(M8) tightening torque .... 12.7 ~ 15.7 Nm
3
-68
ENGINE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW292A
1.3 ~ 1.6 kgf-m
9.8 ~ 11.2 lb-ft
When installing the flywheel, align the alignment
3.
hole mark of the crankshaft with the alignment hole
on the fl ywheel surface. Also, tighten the fl ywheel
mounting bolts to the specifi ed torque after apply-
ing a small amount of oil to them.
Flywheel bolt
tightening torque ............ 54.0 ~ 59.0 Nm
UUVW293A
UUVW294A
5.5 ~ 6.0 kgf-m
40.0 ~ 43.0 lb-ft
SUUV-W00 Apr. 2011