Ezgo 1600xd Repair Manual page 331

HYDRAULIC SYSTEM - DISASSEMBLY, SERVICE AND ASSEMBLY
●
ASSEMBLY
1. When installing the detent ball, apply grease to the
three balls (1) and insert them to the three holes of
the spool. Then, insert the detent ball (2) into the
center.
2. Install the adapter (1) as shown in the fi gure and
tighten it fully with a hand.
REMARK
• The ball is in the floating (detent) status when
seating it onto the section (A) of the adapter and
installing it completely to place it to the section
(B).
SUUV-W00 Apr. 2011
UUVWB59A
3. Insert the springs (double) (1) into the spool as
shown in the fi gure.
UUVWB60A
4. Fit the tool to the lever (1) and apply grease to the
three balls (2). Then, with the lever pushed down,
insert the three balls (2) into the three holes on the
upper section of the spool and place the detent ball
(4) onto the spring (3) in the center.
UUVWB61A
5. Fit the detent housing (1) and screw it in with a
hand.
UUVWB62A
UUVWB63A
UUVWB64A
11
-27