Rear Propeller Shaft Replacement - Ezgo 1600xd Repair Manual

5.8 REAR PROPELLER SHAFT REPLACEMENT

1. Park the vehicle on level ground, apply the parking
brake and stop the engine.
2. Raise and support the cargo bed.
3. Unscrew the parking brake caliper mounting bolts
(1) to remove the caliper assembly (2).
4. Tap the propeller shaft mounting spring pin (1) on
the rear axle case side and unscrew the brake disc
mounting bolts (2) to remove the brake disc.
7
-28
REAR AXLE - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW689A
UUVW671A
UUVW672A
5. Loosen the left and right mounting bolts (1) (M8, 4
EA) for the stabilizer.
6. Pull the propeller shaft toward the rear axle case
with the stabilizer lifted up to separate it from the
transmission case. Then, pull it toward the trans-
mission case to remove it.
REMARK
• If the propeller shaft to be removed is interfered
with the transmission due to its torque angle,
rotate the rear wheels to fi nd the right angle so
that it can be removed without any interference.
UUVW673A
UUVW674A
SUUV-W00 Apr. 2011