ST STM32F205 series Reference Manual page 621

RM0033
Bit 9 ITEVTEN: Event interrupt enable
Bit 8 ITERREN: Error interrupt enable
Bits 7:6 Reserved, must be kept at reset value
Bits 5:0 FREQ[5:0]: Peripheral clock frequency
0: Event interrupt disabled
1: Event interrupt enabled
This interrupt is generated when:
– SB = 1 (Master)
– ADDR = 1 (Master/Slave)
– ADD10= 1 (Master)
– STOPF = 1 (Slave)
– BTF = 1 with no TxE or RxNE event
– TxE event to 1 if ITBUFEN = 1
– RxNE event to 1if ITBUFEN = 1
0: Error interrupt disabled
1: Error interrupt enabled
This interrupt is generated when:
– BERR = 1
– ARLO = 1
– AF = 1
– OVR = 1
– PECERR = 1
– TIMEOUT = 1
– SMBALERT = 1
The FREQ bits must be configured with the APB clock frequency value (I2C peripheral
connected to APB). The FREQ field is used by the peripheral to generate data setup and
hold times compliant with the I2C specifications. The minimum allowed frequency is 2 MHz,
the maximum frequency is limited by the maximum APB frequency and cannot exceed
50 MHz (peripheral intrinsic maximum limit).
0b000000: Not allowed
0b000001: Not allowed
0b000010: 2 MHz
...
0b110010: 50 MHz
Higher than 0b100100: Not allowed
Inter-integrated circuit (I2C) interface
RM0033 Rev 8 621/1378
630