Ssh Redirect Enable - H3C MSR Series Command Reference Manual

<Sysname> system-view
[Sysname] line tty 1
[Sysname-line-tty1] ssh redirect disconnect
Related commands

ssh redirect enable

ssh redirect enable
Use ssh redirect enable to enable SSH redirect for a user line.
Use undo ssh redirect enable to disable SSH redirect for a user line.
Syntax
ssh redirect enable
undo ssh redirect enable
Default
SSH redirect is disabled for a user line.
Views
AUX line view
TTY line view
Predefined user roles
network-admin
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE
/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS
MSR2600-10-X1
MSR 2630
MSR3600-28/3600-51
MSR3600-28-SI/3600-51-SI
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC
MSR 3610/3620/3620-DP/3640/3660
MSR5620/5660/5680
The user line on the SSH redirect server must use the same transmission rate as the destination
device. To set the transmission rate for the user line, use the speed command.
As a best practice, configure the user line on the SSH redirect server to use the same number of stop
bits as the destination device. To identify whether the user line and the destination device are using
the same number of stop bits, use the stopbit-error intolerance command. To change the number
of stop bits, use the stopbits command.
For more information about the transmission rate and stop bits, see the login management
configuration in Fundamentals Configuration Guide.
Command compatibility
No
Yes
Yes
Yes
Yes
Yes
Yes
No
679