Arp Filtering Commands; Arp Filter Binding - H3C MSR Series Command Reference Manual

[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] arp filter source 1.1.1.1

ARP filtering commands

arp filter binding

Use arp filter binding to enable ARP filtering and configure an ARP permitted entry.
Use undo arp filter binding to remove an ARP permitted entry.
Syntax
arp filter binding ip-address mac-address
undo arp filter binding ip-address
Default
ARP filtering is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies a permitted sender IP address.
mac-address: Specifies a permitted sender MAC address.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-
W-LM-HK/810-LMS/810-LUS
MSR2600-10-X1
MSR 2630
MSR3600-28/3600-51
MSR3600-28-SI/3600-51-SI
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC
MSR 3610/3620/3620-DP/3640/3660
MSR5620/5660/5680
If the sender IP and MAC addresses of an ARP packet match an ARP permitted entry, the ARP
packet is permitted. If not, it is discarded.
You can configure a maximum of eight ARP permitted entries on an interface.
You cannot configure both the arp filter source and arp filter binding commands on the same
interface.
1121
Command
compatibility
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes