Portal Packet Log Enable; Portal Pre-Auth Ip-Pool - H3C MSR Series Command Reference Manual

<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] portal pre-auth domain abc
Related commands
display portal

portal packet log enable

Use portal packet log enable to enable logging for portal protocol packets.
Use undo portal packet log enable to disable logging for portal protocol packets.
Syntax
portal packet log enable
undo portal packet log enable
Default
Portal protocol packet logging is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
This feature logs information about portal protocol packets, including the username, IP address,
authentication type, packet type, SSID, and AP MAC. For portal log messages to be sent correctly,
you must also configure the information center on the device. For more information about information
center configuration, see Network Management and Monitoring Configuration Guide.
Examples
# Enable logging for portal protocol packets.
<Sysname> system-view
[Sysname] portal packet log enable
Related commands
portal redirect log enable
portal user log enable

portal pre-auth ip-pool

Use portal pre-auth ip-pool to specify a preauthentication IP address pool for portal users.
Use undo portal pre-auth ip-pool to restore the default.
Syntax
portal [ ipv6 ] pre-auth ip-pool pool-name
undo portal [ ipv6 ] pre-auth ip-pool
Default
No preauthentication IP address pool is specified for portal users.
365