H3C MSR Series Command Reference Manual page 360

Syntax
Interface view:
portal enable method { direct | layer3 | redhcp }
portal ipv6 enable method { direct | layer3 }
undo portal [ ipv6 ] enable
Service template:
portal [ ipv6 ] enable method direct
undo portal [ ipv6 ] enable
Default
Portal authentication is disabled.
Views
Interface view
Service template
Predefined user roles
network-admin
Parameters
ipv6: Enables IPv6 portal authentication. Do not specify this keyword for IPv4 portal authentication.
method: Specifies an authentication mode:
•
direct—Direct authentication.
•
layer3—Cross-subnet authentication.
•
redhcp—Re-DHCP authentication.
Usage guidelines
To modify the portal authentication mode, first execute the undo form of this command to disable
portal authentication.
Make sure the device supports IPv6 ACL and IPv6 forwarding before you enable IPv6 portal
authentication on the interface.
IPv6 portal authentication does not support the re-DHCP authentication mode.
Do not add a portal authentication-enabled Ethernet interface to an aggregation group. Otherwise,
portal authentication cannot take effect on the interface.
You can enable both IPv4 and IPv6 portal authentication on an interface or on a service template.
Only direct portal authentication is supported on a service template.
Do not enable portal authentication on both an interface and a service template.
Examples
# Enable direct IPv4 portal authentication on GigabitEthernet 1/0/1. (Wired application).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] portal enable method direct
# Enable direct IPv4 portal authentication on service template service1. (Wireless application.)
<Sysname> system-view
[Sysname] wlan service-template service1
[Sysname-wlan-st-service1] portal enable method direct
337