H3C MSR Series Command Reference Manual page 765

Field
Bandwidth
Maximum transmission unit
Internet protocol processing
Last clearing of counters
Last 300 seconds input rate
Last 300 seconds output rate
# Display brief information about all SSL VPN AC interfaces.
<Sysname> display interface sslvpn-ac brief
Brief information of interfaces in route mode:
Link: ADM - administratively down
Protocol: (s) - spoofing
Interface
SSLVPN-AC1000
# Display brief information about SSL VPN AC 1000, including the complete interface description.
<Sysname> display interface sslvpn-ac 1000 brief description
Brief information of interfaces in route mode:
Link: ADM - administratively down
Protocol: (s) - spoofing
Interface
SSLVPN-AC1000
# Display information about interfaces in DOWN state and the causes.
<Sysname> display interface sslvpn-ac brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down
Interface
SSLVPN-AC1000
SSLVPN-AC1001
Table 107 Command output
Field
Brief information of interfaces
in route mode:
Link: ADM - administratively
down
Protocol: (s) - spoofing
Description
Expected bandwidth for the interface.
MTU of the interface.
IP address of the interface.
If no IP address is assigned to the interface, this field displays
Internet protocol processing: Disabled, and the interface cannot
process packets.
Primary indicates that the IP address is the primary IP address of
the interface.
Most recent time the counters were cleared by using the reset
counters interface command.
If the reset counters interface command has never been
executed since the device starts up, this field displays Never.
Average input rate in the last 300 seconds.
Average output rate in the last 300 seconds.
Link Protocol Primary IP
UP DOWN --
Link Protocol Primary IP
UP UP 1.1.1.1
Link Cause
ADM
ADM
Description
Brief information about Layer 3 interfaces.
Link status. ADM indicates that the interface has been shut down by using
the shutdown command. To restore the physical state of the interface, use
the undo shutdown command.
(s) indicates that the data link layer protocol state is UP, but the link is
temporarily set up on demand or does not exist.
742
Description
Description
SSLVPN-AC1000 Interface