Portal Redirect Log Enable - H3C MSR Series Command Reference Manual

Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6: Specifies IPv6 portal users. Do not specify this keyword for IPv4 portal users.
pool-name: Specifies an IP address pool by its name, a case-insensitive string of 1 to 63 characters.
Usage guidelines
You must use this command to specify a preauthentication IP address pool on a portal-enabled
interface in the following situation:
•
Portal users access the network through a subinterface of the portal-enabled interface.
•
The subinterface does not have an IP address.
•
Portal users need to obtain IP addresses through DHCP.
DHCP assigns an IP address from the specified IP address pool to a user. Then, the user can use
this IP address to perform portal authentication.
The specified IP address pool takes effect when the following requirements are met:
•
The direct portal authentication mode is used on the interface.
•
The specified IP address pool must have existed and been correctly configured.
Examples
# Create the IPv4 address pool abc for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] portal pre-auth ip-pool abc
Related commands
dhcp server ip-pool (Layer 3—IP Services Command Reference)
display portal
ipv6 dhcp pool (Layer 3—IP Services Command Reference)

portal redirect log enable

Use portal redirect log enable to enable logging for portal redirect.
Use undo portal redirect log enable to disable logging for portal redirect.
Syntax
portal redirect log enable
undo portal redirect log enable
Default
Portal redirect logging is disabled.
Views
System view
Predefined user roles
network-admin
366