Aspf Commands; Aspf Apply Policy (Interface View) - H3C MSR Series Command Reference Manual

ASPF commands

IPv6-related parameters are not supported on the following routers:
•
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-L
MS/810-LUS.
•
MSR3600-28-SI/3600-51-SI.
Commands and descriptions for centralized devices apply to the following routers:
•
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-L
MS/810-LUS.
•
MSR2600-10-X1.
•
MSR 2630.
•
MSR3600-28/3600-51.
•
MSR3600-28-SI/3600-51-SI.
•
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC.
•
MSR 3610/3620/3620-DP/3640/3660.
Commands and descriptions for distributed devices apply to the following routers:
•
MSR5620.
•
MSR 5660.
•
MSR 5680.

aspf apply policy (interface view)

Use aspf apply policy to apply an ASPF policy to an interface.
Use undo aspf apply policy to remove an ASPF policy application from an interface.
Syntax
aspf apply policy aspf-policy-number { inbound | outbound }
undo aspf apply policy aspf-policy-number { inbound | outbound }
Default
No ASPF policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
aspf-policy-number: Specifies an ASPF policy number. The value range for this argument is 1 to 256.
inbound: Applies the ASPF policy to incoming packets.
outbound: Applies the ASPF policy to outgoing packets.
Usage guidelines
To inspect the traffic through an interface, you must apply a configured ASPF policy to that interface.
Make sure a connection initiation packet and the response packet pass through the same interface,
because an ASPF stores and maintains the application layer protocol status based on interfaces.
808