Session Log { Bytes-Active | Packets-Active - H3C MSR Series Command Reference Manual

syn: Specifies the TCP SYN-SENT and SYN-RCV states.
tcp-close: Specifies the TCP CLOSE state.
tcp-est: Specifies the TCP ESTABLISHED state.
tcp-time-wait: Specifies the TCP TIME-WAIT state.
udp-open: Specifies the UDP OPEN state.
udp-ready: Specifies the UDP READY state.
time-value: Specifies the aging time in seconds. The value range is 1 to 100000.
Usage guidelines
This command sets the aging time for stable sessions of the application layer protocols that are not
supported by the session aging-time application command. For persistent sessions, the aging
time is set by the session persistent acl command.
Examples
# Set the aging time for TCP sessions in SYN-SENT and SYN-RCV states to 60 seconds.
<Sysname> system-view
[Sysname] session aging-time state syn 60
Related commands
display session aging-time state
session aging-time application
session persistent acl

session log { bytes-active | packets-active }

Use session log { bytes-active | packets-active } to set a threshold for traffic-based logging.
Use undo session log { bytes-active | packets-active } to restore the default.
Syntax
session log { bytes-active bytes-value | packets-active packets-value }
undo session log { bytes-active | packets-active }
Default
No threshold is set for traffic-based logging.
Views
System view
Predefined user roles
network-admin
Parameters
bytes-value: Specifies the byte-based threshold in the range of 1 to 100000 MB.
packets-value: Specifies the packet-based threshold in the range of 1 to 100000 mega-packets.
Usage guidelines
For this command to take effect, make sure the session statistics collection for software fast
forwarding feature is enabled.
If you set both the traffic-based and time-based logging, the device outputs a session log when
whichever is reached. After outputting a session log, the device resets the traffic counter and restarts
the interval for the session.
912