Timeout Idle - H3C MSR Series Command Reference Manual

Syntax
sslvpn ip address-pool pool-name start-ip-address end-ip-address
undo sslvpn ip address-pool pool-name
Default
No address pools exist.
Views
System view
Predefined user roles
network-admin
Parameters
pool-name: Specifies a name for the address pool, a case-insensitive string of 1 to 31 characters.
start-ip-address end-ip-address: Specifies the start IP address and end IP address for the pool. The
end IP address must be greater than the start IP address. The start IP address and end IP address
cannot be a multicast, broadcast, or loopback address.
Usage guidelines
An SSL VPN gateway uses address pools to assign IP addresses to IP access clients.
To specify an address pool for a policy group, you must first create the address pool by using this
command.
Examples
# Create an address pool named pool1 and specify the address range as 10.1.1.1 to 10.1.1.254.
<Sysname> system-view
[Sysname] sslvpn ip address-pool pool1 10.1.1.1 10.1.1.254

timeout idle

Use timeout idle to set the idle timeout timer for SSL VPN sessions.
Use undo timeout idle to restore the default.
Syntax
timeout idle minutes
undo timeout idle
Default
The idle timeout timer is 30 minutes for SSL VPN sessions.
Views
SSL VPN context view
Predefined user roles
network-admin
Parameters
seconds: Specifies the idle timeout timer in the range of 1 to 1440 minutes.
Usage guidelines
If the idle time of an SSL VPN session exceeds the specified idle timeout time, the session is
terminated.
800