Display Attack-Defense Scan Victim Ipv6 - H3C MSR Series Command Reference Manual

# (Distributed devices in standalone mode/centralized devices in IRF mode.) Display the number of
IPv4 scanning attack victims.
<Sysname> display attack-defense scan victim ip count
Slot 1:
Totally 3 victim IP addresses.
Slot 2:
Totally 0 victim IP addresses.
# (Distributed devices in IRF mode.) Display the number of IPv4 scanning attack victims.
<Sysname> display attack-defense scan victim ip count
Slot 1 in chassis 1:
Totally 3 victim IP addresses.
Slot 2 in chassis 2:
Totally 0 victim IP addresses.
Table 160 Command output
Field
Totally 3 victim IP addresses
IP address
VPN instance
Protocol
Detected on
Duration(min)
Related commands
display attack-defense scan attacker ip
scan detect

display attack-defense scan victim ipv6

Use display attack-defense scan victim ipv6 to display information about IPv6 scanning attack
victims.
Syntax
Centralized devices in standalone mode:
display attack-defense scan victim ipv6 [ interface interface-type interface-number | local ]
[ count ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display attack-defense scan victim ipv6 [ [ interface interface-type interface-number | local ]
[ slot slot-number ] ] [ count ]
Distributed devices in IRF mode:
display attack-defense scan victim ipv6 [ [ interface interface-type interface-number | local ]
[ chassis chassis-number slot slot-number ] ] [ count ]
Views
Any view
Description
Total number of IPv4 scanning attack victims.
IPv4 address of the victim.
MPLS L3VPN instance to which the victim IPv4 address belongs. If the
victim IPv4 address is on the public network, this field displays hyphens
(--).
Name of the protocol.
Where the attack is detected, on the device (Local) or an interface.
The amount of time the attack lasts, in minutes.
1011