Portal Host-Check Enable - H3C MSR Series Command Reference Manual

all: Specifies all portal-free rules.
Usage guidelines
If you specify both the source VLAN and the source Layer 2 interface, the interface must be in the
VLAN.
When you specify an object group in a source-based portal-free rule, make sure the specified object
rule already exists. You can specify only IPv4 and IPv6 address object groups.
Examples
# Configure source-based portal-free rule: specify the rule number as 3, source MAC address as
1-1-1, and source VLAN ID as 10. This rule allows the portal user whose source MAC address is
1-1-1 from VLAN 10 to access network resources without authentication.
<Sysname> system-view
[Sysname] portal free-rule 3 source mac 1-1-1 vlan 10
# Configure a source-based portal-free rule: specify the rule number as 4 and source AP name as
ap10. This rule allows portal users on AP 10 to access network resources without authentication.
<Sysname> system-view
[Sysname] portal free-rule 4 source ap ap10
Related commands
display portal rule

portal host-check enable

Use portal host-check enable to enable validity check on wireless portal clients.
Use undo portal host-check enable to disable validity check on wireless portal clients.
Syntax
portal host-check enable
undo portal host-check enable
Default
Validity check on wireless portal clients is disabled. The device checks wireless portal client validity
according to ARP entries only.
Views
System view
Predefined user roles
network-admin
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-
10-PoE/810-LM-HK/810-W-LM-HK
MSR810-LMS/810-LUS
MSR2600-10-X1
MSR 2630
MSR3600-28/3600-51
Command compatibility
Yes
No
Yes
Yes
Yes
347