Object-Policy Apply Ipv6 - H3C MSR Series Command Reference Manual

Predefined user roles
network-admin
Parameters
object-policy-name: Specifies an IPv4 object policy by its name, a case-insensitive string of 1 to 63
characters.
Usage guidelines
If the specified object policy does not exist, this command fails.
You can apply only one IPv4 object policy to each zone pair. To apply a new IPv4 object policy to an
instance, remove the application of the existing IPv4 object policy.
Examples
# Configure an IPv4 object policy and apply it to a zone pair.
<Sysname> system-view
[Sysname] object-policy ip permit
[Sysname-object-policy-ip-permit] quit
[Sysname] zone-pair security source office destination library
[Sysname-zone-pair-security-office-library] object-policy apply ip permit
Related commands
display object-policy zone-pair security

object-policy apply ipv6

object-policy ip
object-policy apply ipv6
Use object-policy apply ipv6 to apply an IPv6 object policy to a zone pair.
Use undo object-policy apply ipv6 to restore the default.
Syntax
object-policy apply ipv6 object-policy-name
undo object-policy apply ipv6 object-policy-name
Default
IPv6 object policies are not applied to a zone pair.
Views
Zone pair view
Predefined user roles
network-admin
Parameters
object-policy-name: Specifies an IPv6 object policy by its name, a case-insensitive string of 1 to 63
characters.
Usage guidelines
If the specified object policy does not exist, this command fails.
You can apply only one IPv6 object policy to each zone pair. To apply a new IPv6 object policy to an
instance, remove the application of the existing IPv6 object policy.
961